Effect of Cooling Rate on Microstructure, Mechanical and Wear Properties of Mg-2zn and Mg-2zn Alloys

Abstract

In this study, the wear characteristics of Mg-2Zn and Mg2Zn-1Mn alloys in both dry and corrosive conditions, as well as their mechanical properties dependent on cooling rate, were examined. It has been determined that MgZn, Mg2Zn3 and MgZn2 phases are formed together with the α-Mg main matrix in the microstructure of the alloys. The highest tensile strength (188.6 MPa) was observed in section B of Mg-2Zn alloy. With this, section A of the Mg-2Zn-1Mn alloy showed the lowest wear value (0.00144 mm3/N.m) following dry wear. However, under corrosive wear conditions, the lowest wear rate (0.0008 mm3/N.m) was exhibited at B section in Mg-2Zn-1Mn alloy. In the SEM images of the abrasive tips used in the wear tests, it was determined that the scratches occurred along the wear direction, and as a result of the EDX analysis, alloying elements were transferred from the alloys to the abrasive tip. © 2024 Canadian Institute of Mining, Metallurgy and Petroleum.